米葫芦网

RFC1420 - SNMP over IPX

热度:8℃ 发布时间:2024-11-17 21:47:02

Network Working Group S. Bostock
Request for Comments: 1420 Novell, Inc.
Obsoletes: 1298 March 1993
SNMP over IPX
Status of this Memo
This RFCspecifies an IAB standards track protocol for the Internet
community, and requests discussion and suggestions for improvements.
Please refer to the current edition of the "IAB Official Protocol
Standards" for the standardization state and status of this protocol.
Distribution of this memo is unlimited.
Abstract
This document defines a convention for encapsulating Simple Network
Management Protocol (SNMP) [1] packets over the transport mechanism
provided via the Internetwork Packet Exchange (IPX) protocol [2].
1. IntrodUCtion
The Simple Network Management Protocol (SNMP) as defined in [1] is
now used as an integral part of the network management framework for
TCP/IP-based internets. Together with its companion standards, which
define the Structure of Management Information (SMI) [3,4], and the
Management Information Base (MIB) [5], the SNMP has received
widespread deployment in many operational networks running the
Internet suite of protocols.
The success of SNMP in the TCP/IP environment has led to its
deployment in non TCP/IP-based internets. This specification
describes the mapping of SNMP onto the Internetwork Packet Exchange
(IPX) protocol [2] used in Novell NetWare environments.
As noted in [6], the preferred mapping for SNMP is onto UDP [7]. As
such, this specification is intended for use in environments where
UDP transport is not available. No ASPect of this specification
should be construed as a suggestion that, in a heterogeneous
transport environment, a managed agent should support more than one
mapping. Conversely, management stations are strongly encouraged to
support mappings of SNMP onto all popular transports.
2. Mapping SNMP onto IPX
Mapping SNMP onto IPX is straight-forward since IPX provides a
datagram service very similar to that provided by IP/UDP.
Although modifications have been made elsewhere in the NetWare
protocol suite, IPX is identical to the Xerox Internet Datagram
Protocol (IDP) [8]. The socket address space authority is
administered by Novell.
SNMP packets will always set the Packet Type field in the IPX header
to 4 (i.e., Packet Exchange Packet).
2.1 Socket Assignments
SNMP protocol entities will receive GetRequest-PDU, GetNextRequest-
PDU, and SetRequest-PDU messages on socket 36879 (Destination Socket
field set to hexadecimal 900F), and Trap-PDU messages on socket 36880
(Destination Socket field set to hexadecimal 9010).
GetResponse-PDU messages will be addressed to the IPX address and
socket from which the corresponding GetRequest-PDU, GetNextRequest-
PDU, or SetRequest-PDU originated.
2.2 Traps
When SNMP traps are sent over IPX, the agent-addr field in the Trap-
PDU contains the IP-address "0.0.0.0". An SNMP manager may ascertain
the source of the trap based on information provided by the transport
service
2.3 Maximum Message Size
Although SNMP does not require conformant implementations to accept
messages whose length exceeds 484 bytes, it is recommended that
implementations support a maximum SNMP message size of 546 bytes (the
maximum size allowed under IPX). Furthermore, this limit is the
maximum packet length guaranteed to traverse IPX routers which do not
provide fragmentation. Implementors may choose to use longer packet
lengths if the maximum is known, which depends on the intermediate
routers and/or intermediate datalink layer protocols.
3. Document Procurement
This section provides contact points for procurement of selected
documents.
A complete description of IPX may be secured at the following
address:
Novell, Inc.
122 East 1700 South
P. O. Box 5900
Provo, Utah 84601 USA
800 526 5463
Novell Part # 883-000780-001
The specification for IDP (part of XNS) may be ordered from:
Xerox System Institute
475 Oakmead Parkway
Sunnyvale, CA 94086
Attn.: Fonda Pallone
(415) 813-7164
4. Acknowledgments
This specification was derived from RFC1298, based on discussions in
the IETF"s "SNMP over a Multiprotocol Internet" Working Group.
5. References
[1] Case, J., Fedor, M., Schoffstall, M., and J. Davin, "Simple
Network Management Protocol", STD 15, RFC1157, SNMP Research,
Performance Systems International, Performance Systems
International, MIT Laboratory for Computer Science, May 1990.
[2] Novell, Inc., "NetWare System Technical Interface Overview", part
number 883-000780-001, June 1989.
[3] Rose M., and K. McCloghrie, "Structure and Identification of
Management Information for TCP/IP-based internets", STD 16, RFC
1155, Performance Systems International, Hughes LAN Systems, May
1990.
[4] Rose, M., and K. McCloghrie, Editors, "Concise MIB Definitions",
STD 16, RFC1212, Performance Systems International, Hughes LAN
Systems, March 1991.
[5] Rose M., and K. McCloghrie, Editors, "Management Information Base
for Network Management of TCP/IP-based Internets", STD 17, RFC
1213, Hughes LAN Systems, Inc., Performance Systems
International, March 1991.
[6] Kastenholz, F., "SNMP Communications Services", RFC1270,
Clearpoint Research Corporation, October 1991.
[7] Postel J., "User Datagram Protocol", STD 6, RFC768,
USC/Information Sciences Institute, August 1980.
[8] Xerox System Integration Standard, "Internet Transport
Protocols", XSIS 028112, Xerox Corporation, December 1981.
6. Security Considerations
Security issues are not discussed in this memo.
7. Author"s Address
Steve Bostock
Novell, Inc.
2180 Fortune Drive
San Jose, CA 95131
Phone: 408 473 8203
Fax: 408 435 1706
Email: steveb@novell.com

网友评论
评论
发 布

更多软件教程
  • 软件教程推荐
更多+
Greenfoot设置中文的方法

Greenfoot设置中文的方法

Greenfoot是一款简单易用的Java开发环境,该软件界面清爽简约,既可以作为一个开发框使用,也能够作为集成开发环境使用,操作起来十分简单。这款软件支持多种语言,但是默认的语言是英文,因此将该软件下载到电脑上的时候,会发现软件的界面语言是英文版本的,这对于英语基础较差的朋友来说,使用这款软件就会...

07-05

Egret UI Editor修改快捷键的方法

Egret UI Editor修改快捷键的方法

Egret UI Editor是一款开源的2D游戏开发代码编辑软件,其主要功能是针对Egret项目中的Exml皮肤文件进行可视化编辑,功能十分强大。我们在使用这款软件的过程中,可以将一些常用操作设置快捷键,这样就可以简化编程,从而提高代码编辑的工作效率。但是这款软件在日常生活中使用得不多,并且专业性...

07-05

KittenCode新建项目的方法

KittenCode新建项目的方法

KittenCode是一款十分专业的编程软件,该软件给用户提供了可视化的操作界面,支持Python语言的编程开发以及第三方库管理,并且提供了很多实用的工具,功能十分强大。我们在使用这款软件进行编程开发的过程中,最基本、最常做的操作就是新建项目,因此我们很有必要掌握新建项目的方法。但是这款软件的专业性...

07-05

Thonny设置中文的方法

Thonny设置中文的方法

Thonny是一款十分专业的Python编辑软件,该软件界面清爽简单,给用户提供了丰富的编程工具,具备代码补全、语法错误显示等功能,非常的适合新手使用。该软件还支持多种语言,所以在下载这款软件的时候,有时候下载到电脑中的软件是英文版本的,这对于英语基础较差的小伙伴来说,使用这款软件就会变得十分困难,...

07-05

最新软件下载