米葫芦网

RFC2394 - IP Payload Compression Using DEFLATE

热度:11℃ 发布时间:2024-11-18 09:06:06

Network Working Group R. Pereira
Request for Comments: 2394 TimeStep Corporation
Category: Informational December 1998
IP Payload Compression Using DEFLATE
Status of this Memo
This memo provides information for the Internet community. It does
not specify an Internet standard of any kind. Distribution of this
memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (1998). All Rights Reserved.
Abstract
This document describes a compression method based on the DEFLATE
compression algorithm. This document defines the application of the
DEFLATE algorithm to the IP Payload Compression Protocol.
Table of Contents
1. IntrodUCtion...................................................2
1.1 The DEFLATE Compression Algorithm...........................2
1.2 Licensing...................................................2
1.3 Specification of Requirements...............................3
2. DEFLATE Algorithm Implementation...............................3
2.1 Compression.................................................3
2.2 Decompression...............................................4
3. Thresholds.....................................................4
4. IPSec Transform Identifier.....................................4
5. Security Considerations........................................4
6. References.....................................................5
7. Acknowledgments................................................5
8. Editor"s Address...............................................5
9. Full Copyright Statement.......................................6
1. Introduction
The IP Payload Compression Protocol allows the compression of IP
datagrams by supporting different compression algorithms. This
document describes how to integrate the DEFLATE compression algorithm
[Deutsch96] into IPCOMP [IPCOMP].
This document SHOULD be read in conjunction with [IPCOMP] and MUST be
taken in its context.
1.1 The DEFLATE Compression Algorithm
The "deflate" compression format [Deutsch96], as used by the PKZIP
and gzip compressors and as embodied in the freely and widely
distributed zlib [Gailly95] library source code, has the following
features:
o an apparently unencumbered encoding and compression algorithm,
with an open and publicly-available specification.
o low-overhead escape mechanism for incompressible data. The PPP
Deflate specification offers options to reduce that overhead
further.
o heavily used for many years in networks, on modem and other point-
to-point links to transfer files for personal computers and
workstations.
o easily achieves 2:1 compression on the Calgary corpus [Corpus90]
using less than 64KBytes of memory on both sender and receive.
1.2 Licensing
The zlib source is widely and freely available, subject to the
following copyright:
(C) 1995 Jean-Loup Gailly and Mark Adler
This software is provided "as-is", without any eXPress or implied
warranty. In no event will the authors be held liable for any
damages arising from the use of this software.
Permission is granted to anyone to use this software for any
purpose, including commercial applications, and to alter it and
redistribute it freely, subject to the following restrictions:
1. The origin of this software must not be misrepresented; you
must not claim that you wrote the original software. If you use
this software in a product, an acknowledgment in the product
documentation would be appreciated but is not required.
2. Altered source versions must be plainly marked as such, and
must not be misrepresented as being the original software.
3. This notice may not be removed or altered from any source
distribution.
Jean-Loup Gailly Mark Adler
gzip@prep.ai.mit.edu madler@alumni.caltech.edu
If you use the zlib library in a product, we would appreciate
*not* receiving lengthy legal documents to sign. The sources are
provided for free but without warranty of any kind. The library
has been entirely written by Jean-Loup Gailly and Mark Adler; it
does not include third-party code.
The deflate format and compression algorithm are based on Lempel-Ziv
LZ77 compression; extensive research has been done by the GNU Project
and the Portable Network Graphics working group supporting its patent
free status.
1.3 Specification of Requirements
The keyWords "MUST", "MUST NOT", "REQUIRED", "SHOULD", "SHOULD NOT",
and "MAY" that appear in this document are to be interpreted as
described in [Bradner97].
2. DEFLATE Algorithm Implementation
The DEFLATE compression algorithm was designed by Phil Katz and its
details are publicly available in [Deutsch96]. Thus it is a good
freely available algorithm to implement within IPCOMP.
Compression and decompression algorithm details should be followed as
outlined in [Deutsch96] or the use of a software library may be
preferable. Since IPComp is a stateless protocol, history MUST be
cleared between packets when either compressing or decompressing.
2.1 Compression
As defined in [IPCOMP], the compression process is determined by the
IP Compression Association (IPCA). The IPCA MUST define the DEFLATE
algorithm for the process within this document to take place.
The compression process entails compressing the data from the IP
datagram and placing the result after the IPComp header. For
example, compressing a TCP datagram;
Before: IP TCP ...
After: IP IPCOMP (TCP ...)
Please note how everything after the IPCOMP header is compressed.
DEFLATE allows for a number of compression levels ranging from best
compression but slow to fast compression. The level that one
compresses data is implementation dependant since it is always
compatible with the decompression algorithm.
2.2 Decompression
As in the compression process, the IPCA defines the parameters and
algorithm to utilize for the decompression process.
As defined in [IPCOMP] the data after the IPComp header is
decompressed and replaces the IPComp header within the IP header.
Decompression using the DEFLATE algorithm follows the decompression
process defined in [Deutsch96].
3. Thresholds
As stated in [IPCOMP], compression on small buffers does not usually
work as well as on fast links since the time it takes to compress is
slower than the time to transport the data. Informal tests show that
the average buffer size that produces larger results is around 90
bytes. Thus implementations SHOULD NOT attempt to compress buffers
smaller than 90 bytes.
Other than a packet size limit, no compressibility test as defined in
[IPCOMP] is outlined in this document.
4. IPSec Transform Identifier
[IPDOI] states that the ISAKMP IPCOMP transform ID for the DEFLATE
compression algorithm is IPCOMP_DEFLATE. No other ISAKMP parameters
are required for the IPCOMP DEFLATE algorithm.
5. Security Considerations
This document does not add any further security considerations that
[IPCOMP] and [Deutsch96] have already declared.
6. References
[IPCOMP] Shacham, A., Monsour, R., Pereira, R., and M. Thomas, "IP
Payload Compression Protocol (IPComp)", RFC2393,
December 1998.
[Deutsch96] Deutsch, P., "DEFLATE Compressed Data Format
Specification version 1.3", RFC1951, May 1996.
[IPDOI] Piper, D., "The Internet IP Security Domain of
Interpretation for ISAKMP", RFC2407, November 1998.
[Corpus90] Bell, T.C., Cleary, G. G. and Witten, I.H., "Text
Compression", Prentice_Hall, Englewood Cliffs NJ, 1990.
The compression corpus itself can be found in
FTP://ftp.uu.net/pub/archiving/zip/
[Gailly95] Gailly, J.-L., "Zlib 0.95 beta"
7. Acknowledgments
The author wishes to thank all of the active members of the IPPCP
working group especially Abraham Shacham and Naganand Doraswamy.
8. Editor"s Address
Roy Pereira
TimeStep Corporation
Phone: +1 (613) 599-3610 x 4808
EMail: rpereira@timestep.com
The IP Payload Compression Protocol (IPPCP) working group can be
contacted via email (ippcp@cisco.com) or through its chair:
Naganand Dorswamy
Bay Networks
EMail: naganand@baynetworks.com
9. Full Copyright Statement
Copyright (C) The Internet Society (1998). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

网友评论
评论
发 布

更多软件教程
  • 软件教程推荐
更多+
Greenfoot设置中文的方法

Greenfoot设置中文的方法

Greenfoot是一款简单易用的Java开发环境,该软件界面清爽简约,既可以作为一个开发框使用,也能够作为集成开发环境使用,操作起来十分简单。这款软件支持多种语言,但是默认的语言是英文,因此将该软件下载到电脑上的时候,会发现软件的界面语言是英文版本的,这对于英语基础较差的朋友来说,使用这款软件就会...

07-05

Egret UI Editor修改快捷键的方法

Egret UI Editor修改快捷键的方法

Egret UI Editor是一款开源的2D游戏开发代码编辑软件,其主要功能是针对Egret项目中的Exml皮肤文件进行可视化编辑,功能十分强大。我们在使用这款软件的过程中,可以将一些常用操作设置快捷键,这样就可以简化编程,从而提高代码编辑的工作效率。但是这款软件在日常生活中使用得不多,并且专业性...

07-05

KittenCode新建项目的方法

KittenCode新建项目的方法

KittenCode是一款十分专业的编程软件,该软件给用户提供了可视化的操作界面,支持Python语言的编程开发以及第三方库管理,并且提供了很多实用的工具,功能十分强大。我们在使用这款软件进行编程开发的过程中,最基本、最常做的操作就是新建项目,因此我们很有必要掌握新建项目的方法。但是这款软件的专业性...

07-05

Thonny设置中文的方法

Thonny设置中文的方法

Thonny是一款十分专业的Python编辑软件,该软件界面清爽简单,给用户提供了丰富的编程工具,具备代码补全、语法错误显示等功能,非常的适合新手使用。该软件还支持多种语言,所以在下载这款软件的时候,有时候下载到电脑中的软件是英文版本的,这对于英语基础较差的小伙伴来说,使用这款软件就会变得十分困难,...

07-05

最新软件下载