米葫芦网

RFC2471 - IPv6 Testing Address Allocation

热度:8℃ 发布时间:2024-11-18 09:04:37

Network Working Group R. Hinden
Request for Comments: 2471 Nokia
Obsoletes: 1897 R. Fink
Category: EXPerimental LBNL
J. Postel
ISI
December 1998
IPv6 Testing Address Allocation
Status of this Memo
This memo defines an Experimental Protocol for the Internet
community. It does not specify an Internet standard of any kind.
Discussion and suggestions for improvement are requested.
Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (1998). All Rights Reserved.
1.0 IntrodUCtion
This document describes an allocation plan for IPv6 addresses to be
used in testing IPv6 prototype software. These addresses are
temporary and will be reclaimed in the future. Any IPv6 system using
these addresses will have to renumber at some time in the future.
These addresses will not to be routable in the Internet other than
for IPv6 testing.
The address format for the IPv6 test address is consistent with the
"Aggregatable Global Unicast Address Allocation" [AGGR] and "TLA and
NLA Assignment Rules" [TLAASN].
This document is intended to replace RFC1897 "IPv6 Testing Address
Allocation", January 1996. RFC1897 will become historic.
The addresses described in this document are consistent with the IPv6
Addressing Architecture [ARCH]. They may be assigned to nodes
manually, with IPv6 Auto Address Allocation [AUTO], or with DHCP for
IPv6 [DHCPv6].
The key Words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC2119].
2.0 Address Format
The Aggregatable Global Unicast Address Allocation format defined in
[AGGR] is as follows:
3 13 32 16 64 bits
+---+-----+-----------+--------+--------------------------------+
FP TLA NLA ID SLA ID Interface ID
ID
+---+-----+-----------+--------+--------------------------------+
where:
FP = 001 = Format Prefix
This is the Format Prefix used to identify aggregatable
global unicast addresses.
TLA = 0x1FFE = Top-Level Aggregation Identifier
This is a TLA ID assigned by the IANA for 6bone testing under
the auspices of the IETF IPng Transition Working Group 6bone
testbed activity. It is to be administered by the chair of
the 6bone activity (currently Bob Fink <rlfink@lbl.gov>).
The use of this TLA ID is temporary. All users of these
addresses in this TLA ID will be required to renumber at some
time in the future.
NLA ID = Next-Level Aggregation Identifier
The NLA ID space will be assigned, by the TLA ID
administrator, in an addressing hierarchy sufficient to
identify transit networks and end user sites consistent with
the architecture and topology of the 6bone. This will provide
a multi-level transit service consistent with the 6bone goals
of fully testing IPv6 technology in real use environments.
SLA ID = Site-Level Aggregation Identifier
The SLA ID field is used by an individual organization to
create its own local addressing hierarchy and to identify
subnets. Assignment of the SLA ID field is the
responsibility of each individual organization.
Interface ID
This is the interface identifier of the interface on the link
as defined in the appropriate IPv6 over <link> document, such
as [ETHER], [FDDI], etc.
4.0 References
[ARCH] Hinden, R., "IP Version 6 Addressing Architecture",
RFC2373, July 1998.
[AGGR] Hinden, R., Deering, S., O"Dell, M., "An Aggregatable
Global Unicast Address Format", RFC2374, July 1998.
[AUTO] Thompson, S. and T. Narten, "IPv6 Stateless Address
Autoconfiguration", RFC1971, August 1996.
[DHCP6] Bound, J., "Host Configuration Protocol for IPv6", Work in
Progress.
[ETHER] Crawford, M., "Transmission of IPv6 Packets over Ethernet
Networks", RFC2464, December 1998.
[FDDI] Crawford, M., "Transmission of IPv6 Packets over FDDI
Networks", RFC2467, December 1998.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC2119, March 1997.
[TLAASN] Hinden, R., "TLA and NLA Assignment Rules", Work in
Progress.
5.0 Security Considerations
This document defines a test approach for creating aggregatable
address consistent with [AGGR]. It does not have any direct impact
on Internet infrastructure security. Authentication of IPv6 packets
is defined in [AUTH].
6.0 Authors" Addresses
Robert M. Hinden
Nokia
232 Java Drive
Sunnyvale, CA 94089
USA
Phone: +1 408 990-2004
EMail: hinden@iprg.nokia.com
Robert Fink
Lawrence Berkeley National Laboratory
MS 50A-3111
Berkeley, CA 94720
USA
Phone: +1 510 486-5692
EMail: rlfink@lbl.gov
Jon Postel (Deceased)
Information Sciences Institute
4676 Admiralty Way
Marina del Rey, CA 90292-6695
USA
7.0 Full Copyright Statement
Copyright (C) The Internet Society (1998). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

网友评论
评论
发 布

更多软件教程
  • 软件教程推荐
更多+
Greenfoot设置中文的方法

Greenfoot设置中文的方法

Greenfoot是一款简单易用的Java开发环境,该软件界面清爽简约,既可以作为一个开发框使用,也能够作为集成开发环境使用,操作起来十分简单。这款软件支持多种语言,但是默认的语言是英文,因此将该软件下载到电脑上的时候,会发现软件的界面语言是英文版本的,这对于英语基础较差的朋友来说,使用这款软件就会...

07-05

Egret UI Editor修改快捷键的方法

Egret UI Editor修改快捷键的方法

Egret UI Editor是一款开源的2D游戏开发代码编辑软件,其主要功能是针对Egret项目中的Exml皮肤文件进行可视化编辑,功能十分强大。我们在使用这款软件的过程中,可以将一些常用操作设置快捷键,这样就可以简化编程,从而提高代码编辑的工作效率。但是这款软件在日常生活中使用得不多,并且专业性...

07-05

KittenCode新建项目的方法

KittenCode新建项目的方法

KittenCode是一款十分专业的编程软件,该软件给用户提供了可视化的操作界面,支持Python语言的编程开发以及第三方库管理,并且提供了很多实用的工具,功能十分强大。我们在使用这款软件进行编程开发的过程中,最基本、最常做的操作就是新建项目,因此我们很有必要掌握新建项目的方法。但是这款软件的专业性...

07-05

Thonny设置中文的方法

Thonny设置中文的方法

Thonny是一款十分专业的Python编辑软件,该软件界面清爽简单,给用户提供了丰富的编程工具,具备代码补全、语法错误显示等功能,非常的适合新手使用。该软件还支持多种语言,所以在下载这款软件的时候,有时候下载到电脑中的软件是英文版本的,这对于英语基础较差的小伙伴来说,使用这款软件就会变得十分困难,...

07-05

最新软件下载