米葫芦网

RFC3138 - Extended Assignments in 233/8

热度:9℃ 发布时间:2023-11-16 19:57:43

Network Working Group D. Meyer
Request for Comments: 3138 Sprint
Category: Informational June 2001
Extended Assignments in 233/8
Status of this Memo
This memo provides information for the Internet community. It does
not specify an Internet standard of any kind. Distribution of this
memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2001). All Rights Reserved.
Abstract
This memo provides describes the mapping of the GLOP addresses
corresponding to the private AS space.
1. IntrodUCtion
RFC2770 [RFC2770] describes an eXPerimental policy for use of the
class D address space using 233/8. The technique described there
maps 16 bits of Autonomous System number (AS) into the middle two
octets of 233/8 to yield a /24. While this technique has been
successful, the assignments are inefficient in those cases in which a
/24 is too small or the user doesn"t have its own AS.
RFC1930 [RFC1930] defines the private AS space to be 64512 through
65535. This memo expands on RFC2770 to allow routing registries to
assign multicast addresses from the GLOP space corresponding to the
RFC1930 private AS space. This space will be referred to as the
EGLOP (Extended GLOP) address space.
This memo is a product of the Multicast Deployment Working Group
(MBONED) in the Operations and Management Area of the Internet
Engineering Task Force. Submit comments to <mboned@ns.uoregon.edu>
or the authors.
The terms "Specification Required", "Expert Review", "IESG Approval",
"IETF Consensus", and "Standards Action", are used in this memo to
refer to the processes described in [RFC2434]. The keyWords MUST,
MUST NOT, MAY, OPTIONAL, REQUIRED, RECOMMENDED, SHALL, SHALL NOT,
SHOULD, SHOULD NOT are to be interpreted as defined in RFC2119
[RFC2119].
2. Overview
http://www.iana.org/assignments/multicast-addresses defines a
mechanism for assignment of multicast addresses that are generally
for use in network control applications. It is envisioned that those
addresses assigned from the EGLOP space (233.252.0.0 -
233.255.255.255) will be used by applications that cannot use
Administratively Scoped Addressing [RFC2365], GLOP Addressing
[RFC2770], or Source Specific Multicast (Source Specific Multicast,
or SSM, is an extension of IP Multicast in which traffic is forwarded
to receivers from only those multicast sources for which the
receivers have explicitly expressed interest, and is primarily
targeted at one-to-many (broadcast) applications).
3. Assignment Criteria
Globally scoped IPv4 multicast addresses in the EGLOP space are
assigned by a Regional Registry (RIR). An applicant MUST, as per
[IANA], show that the request cannot be satisfied using
Administratively Scoped addressing [RFC2365], GLOP addressing
[RFC2770], or SSM. The fine-grained assignment policy is left to the
assigning RIR.
4. Security Considerations
The assignment scheme described in this document does not effect the
security properties of the the single source or any source multicast
service models.
5. Acknowledgments
Kurt Kayser, Mirjam Kuehne, Michelle Schipper and Randy Bush provided
many insightful comments on earlier versions of this document.
6. Author"s Address
David Meyer
Sprint
12502 Sunrise Valley Dr
Reston VA, 20191
EMail: dmm@sprint.net
7. References
[IANA] http://www.iana.org/assignments/multicast-addresses
[RFC1930] Hawkinson J. and T. Bates, "Guidelines for
creation, selection, and registration of an
Autonomous System (AS)", RFC1930, March 1996.
[RFC2026] Bradner, S., "The Internet Standards Process --
Revision 3", BCP 9, RFC2026, October 1996.
[RFC2119] Bradner, S., "Key words for use in RFCs to
Indicate Requirement Levels", BCP 14, RFC2119,
March 1997.
[RFC2365] Meyer, D., "Administratively Scoped IP Multicast",
RFC2365, July 1998.
[RFC2770] Meyer, D. and P. Lothberg, "GLOP Addressing in
233/8", RFC2770, February 2000.
[RFC2780] Bradner, S. and V. Paxson, "IANA Allocation
Guidelines For Values In the Internet Protocol
and Related Headers", BCP 37, RFC2780, March
2000.
Full Copyright Statement
Copyright (C) The Internet Society (2001). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Acknowledgement
Funding for the RFCEditor function is currently provided by the
Internet Society.

网友评论
评论
发 布

更多软件教程
  • 软件教程推荐
更多+
Greenfoot设置中文的方法

Greenfoot设置中文的方法

Greenfoot是一款简单易用的Java开发环境,该软件界面清爽简约,既可以作为一个开发框使用,也能够作为集成开发环境使用,操作起来十分简单。这款软件支持多种语言,但是默认的语言是英文,因此将该软件下载到电脑上的时候,会发现软件的界面语言是英文版本的,这对于英语基础较差的朋友来说,使用这款软件就会...

07-05

Egret UI Editor修改快捷键的方法

Egret UI Editor修改快捷键的方法

Egret UI Editor是一款开源的2D游戏开发代码编辑软件,其主要功能是针对Egret项目中的Exml皮肤文件进行可视化编辑,功能十分强大。我们在使用这款软件的过程中,可以将一些常用操作设置快捷键,这样就可以简化编程,从而提高代码编辑的工作效率。但是这款软件在日常生活中使用得不多,并且专业性...

07-05

KittenCode新建项目的方法

KittenCode新建项目的方法

KittenCode是一款十分专业的编程软件,该软件给用户提供了可视化的操作界面,支持Python语言的编程开发以及第三方库管理,并且提供了很多实用的工具,功能十分强大。我们在使用这款软件进行编程开发的过程中,最基本、最常做的操作就是新建项目,因此我们很有必要掌握新建项目的方法。但是这款软件的专业性...

07-05

Thonny设置中文的方法

Thonny设置中文的方法

Thonny是一款十分专业的Python编辑软件,该软件界面清爽简单,给用户提供了丰富的编程工具,具备代码补全、语法错误显示等功能,非常的适合新手使用。该软件还支持多种语言,所以在下载这款软件的时候,有时候下载到电脑中的软件是英文版本的,这对于英语基础较差的小伙伴来说,使用这款软件就会变得十分困难,...

07-05

最新软件下载