米葫芦网

RFC3180 - GLOP Addressing in 233/8

热度:4℃ 发布时间:2023-11-16 19:57:53

Network Working Group D. Meyer
Request for Comments: 3180 P. Lothberg
Obsoletes: 2770 Sprint
BCP: 53 September 2001
Category: Best Current Practice
GLOP Addressing in 233/8
Status of this Memo
This document specifies an Internet Best Current Practices for the
Internet Community, and requests discussion and suggestions for
improvements. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2001). All Rights Reserved.
Abstract
This document defines the policy for the use of 233/8 for statically
assigned multicast addresses.
1. IntrodUCtion
It is envisioned that the primary use of this space will be many-to-
many applications. This allocation is in addition to those described
on [IANA] (e.g., [RFC2365]). The IANA has allocated 223/8 as per RFC
2770 [RFC2770]. This document obsoletes RFC2770.
2. Problem Statement
Multicast addresses have traditionally been allocated by a dynamic
mechanism such as SDR [RFC2974]. However, many current multicast
deployment models are not amenable to dynamic allocation. For
example, many content aggregators require group addresses that are
fixed on a time scale that is not amenable to allocation by a
mechanism such as described in [RFC2974]. Perhaps more seriously,
since there is not general consensus by providers, content
aggregators, or application writers as to the allocation mechanism,
the Internet is left without a coherent multicast address allocation
scheme.
The MALLOC working group has created a specific strategy for global
multicast address allocation [RFC2730, RFC2909]. However, this
approach has not been widely implemented or deployed. This document
proposes a solution for a subset of the problem, namely, those cases
not covered by Source Specific Multicast.
3. Address Space
The IANA has allocated 223/8 as per RFC2770 [RFC2770]. RFC2770
describes the administration of the middle two octets of 233/8 in a
manner similar to that described in RFC1797:
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
233 16 bits AS local bits
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
3.1. Example
Consider, for example, AS 5662. Written in binary, left padded with
0s, we get 0001011000011110. Mapping the high order octet to the
second octet of the address, and the low order octet to the third
octet, we get 233.22.30/24.
4. Allocation
As mentioned above, the allocation proposed here follows the RFC1797
(case 1) allocation scheme, modified as follows: the high-order octet
has the value 233, and the next 16 bits are a previously assigned
Autonomous System number (AS), as registered by a network registry
and listed in the RWhois database system. This allows a single /24
per AS.
As was the case with RFC1797, using the AS number in this way allows
automatic assignment of a single /24 to each service provider and
does not require an additional registration step.
4.1. Private AS Space
The part of 233/8 that is mapped to the private AS space [RFC1930] is
assigned to the IRRs [RFC3138].
5. Large AS Numbers
It is important to note that this approach will work only for two
octet AS numbers. In particular, it does not work for any AS number
extension scheme.
6. Security Considerations
The approach described here may have the effect of reduced eXPosure
to denial-of-service attacks based on dynamic allocation. Further,
since dynamic assignment does not cross domain boundaries, well-known
intra-domain security techniques can be applied.
7. IANA Considerations
The IANA has assigned 233/8 for this purpose.
8. Acknowledgments
This proposal originated with Peter Lothberg"s idea that we use the
same allocation (AS based) as described in RFC1797. Randy Bush and
Mark Handley contributed many insightful comments, and Pete and
Natalie Whiting contributed greatly to the readability of this
document.
9. References
[IANA] http://www.iana.org/numbers.Html
[RFC1797] IANA, "Class A Subnet Experiment", RFC1797, April 1995.
[RFC1930] Hawkinson, J. and T. Bates, "Guidelines for creation,
selection, and registration of an Autonomous System (AS)",
RFC1930, March 1996.
[RFC2365] Meyer, D., "Administratively Scoped IP Multicast", RFC
2365, July 1998.
[RFC2374] Hinden, R., O"Dell, M. and S. Deering, "An IPv6
Aggregatable Global Unicast Address Format", RFC2374, July
1998.
[RFC2730] Hanna, S., Patel, B. and M. Shah, "Multicast Address
Dynamic Client Allocation Protocol (MADCAP)", RFC2730,
December 1999.
[RFC2770] Meyer, D. and P. Lothberg, "GLOP Addressing in 233/8", RFC
2770, February 2000.
[RFC2909] Radoslavov, P., Estrin, D., Govindan, R., Handley, M.,
Kumar, S. and D. Thaler, "The Multicast Address-Set Claim
(MASC) Protocol", RFC2909, September 2000.
[RFC2974] Handley, M., Perkins, C. and E. Whelan, "Session
Announcement Protocol", RFC2974, October 2000.
[RFC3138] Meyer, D., "Extended Assignments in 233/8", RFC3138, June
2001.
10. Authors" Addresses
David Meyer
Sprint
VARESA0104
12502 Sunrise Valley Drive
Reston VA, 20196
EMail: dmm@sprint.net
Peter Lothberg
Sprint
VARESA0104
12502 Sunrise Valley Drive
Reston VA, 20196
EMail: roll@sprint.net
11. Full Copyright Statement
Copyright (C) The Internet Society (2001). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Acknowledgement
Funding for the RFCEditor function is currently provided by the
Internet Society.

网友评论
评论
发 布

更多软件教程
  • 软件教程推荐
更多+
Greenfoot设置中文的方法

Greenfoot设置中文的方法

Greenfoot是一款简单易用的Java开发环境,该软件界面清爽简约,既可以作为一个开发框使用,也能够作为集成开发环境使用,操作起来十分简单。这款软件支持多种语言,但是默认的语言是英文,因此将该软件下载到电脑上的时候,会发现软件的界面语言是英文版本的,这对于英语基础较差的朋友来说,使用这款软件就会...

07-05

Egret UI Editor修改快捷键的方法

Egret UI Editor修改快捷键的方法

Egret UI Editor是一款开源的2D游戏开发代码编辑软件,其主要功能是针对Egret项目中的Exml皮肤文件进行可视化编辑,功能十分强大。我们在使用这款软件的过程中,可以将一些常用操作设置快捷键,这样就可以简化编程,从而提高代码编辑的工作效率。但是这款软件在日常生活中使用得不多,并且专业性...

07-05

KittenCode新建项目的方法

KittenCode新建项目的方法

KittenCode是一款十分专业的编程软件,该软件给用户提供了可视化的操作界面,支持Python语言的编程开发以及第三方库管理,并且提供了很多实用的工具,功能十分强大。我们在使用这款软件进行编程开发的过程中,最基本、最常做的操作就是新建项目,因此我们很有必要掌握新建项目的方法。但是这款软件的专业性...

07-05

Thonny设置中文的方法

Thonny设置中文的方法

Thonny是一款十分专业的Python编辑软件,该软件界面清爽简单,给用户提供了丰富的编程工具,具备代码补全、语法错误显示等功能,非常的适合新手使用。该软件还支持多种语言,所以在下载这款软件的时候,有时候下载到电脑中的软件是英文版本的,这对于英语基础较差的小伙伴来说,使用这款软件就会变得十分困难,...

07-05

最新软件下载